Can You Put Regular Clear Polish Over Gel

Download Article

Download Article

If y'all like the durability of a gel manicure merely want the range of colors you lot tin can go with regular nail polish, you may take wondered if you can mix both types of shine together. Fortunately, if you're careful and patient, yous tin! For a simple combined manicure, apply your regular polish then add a gel topcoat one time it's dry. For a little extra durability, make a "gelly sandwich" by layering regular smoothen between ii gel coats.

1. 1

   Use your regular polish every bit you normally would. Polish your nails with regular nail polish in the color of your choice. To assistance the smoothen adhere meliorate, buff and clean your nails first. You tin can also prep your nails with a regular (not-gel) base coat if you wish.^[ane]

   • For a more intense or opaque colour, add multiple layers of polish. However, endeavor not to make them too thick, or the gel topcoat may not hold as well.
   • Apply the smooth upward to the ends of your nails, but don't cap the gratuitous border.

2. 2

   Allow your polish to dry completely. This is a crucial step to making the polish and gel combo work! Earlier applying the gel topcoat, give your blast polish several hours to dry. Make sure the polish has stale completely before you lot go along.^[two]

   • Requite the smooth at least four-half dozen hours to dry. Ideally, you should let it cure for a total 24 hours.
   • You may need more drying fourth dimension if y'all've applied multiple layers of smoothen.
   • If the shine doesn't dry out completely, the topcoat may peel off. The polish might also wrinkle or crack under the gel topcoat after you cure the gel.^[3]

   Advertizement

3. 

   three

   Brush on the gel topcoat. One time your nails are dry out, use a layer of gel topcoat. Brush from the base of each blast to the tip.^[4] Swipe a little topcoat on the gratuitous edge of the nail to cap it off.^[5]

   • If you get whatever gel on your skin or cuticle, wipe it off before you lot cure the gel. Otherwise, information technology will be very hard to have off!

4. 4

   Cure the topcoat under an LED or UV lamp. Place your mitt in an LED or UV nail curing lamp to dry the gel. Go out your nails under the lamp for the recommended corporeality of time.^[6]

   • Await at the characterization on your topcoat to decide the correct curing time. Typically, y'all will need to cure for 30 seconds under an LED lamp, or 2 minutes nether a UV lamp.^[8]
   • You lot can purchase a gel nail drying lamp online, in a department store, or from a beauty supply store.

   Warning: Using UV or LED curing lamps can expose your pare to high levels of UV radiation, leading to skin damage over fourth dimension. If you go frequent gel manicures, protect your hands with a layer of broad-spectrum sunscreen or a pair of protective UV-shielding manicure gloves.^[7]

5. 

   5

   Wipe away the tacky layer with an alcohol wipe. Afterward you cure the gel topcoat, there volition be a mucilaginous layer on elevation of your nails. To remove this layer, pour some 91% isopropyl booze onto a lint-complimentary wipe and wipe each nail. If yous prefer, you can also use dispensable alcohol wipes.^[nine]

   • Avoid using cotton fiber balls, since these can leave lint on your nails.
   • If possible, employ a carve up wipe for each nail. Using the same wipe on multiple nails can dull your topcoat.
   • If your cuticles feel dry, give the alcohol i-2 minutes to dry out and and so wipe on a fiddling cuticle oil.^[10]

   Advertisement

1. 

   1

   Buff your nails to remove whatever polish. Earlier yous apply the gel base coat, you'll demand to slightly roughen the surface of your nails. This volition allow the gel to attach better. Gently get over your nail with a buffer or file with a grit of 220 or college.^[11] Swipe the buffer over each nail 6 to 8 times in an X shape, using shine strokes.^[12]

   • Take care not to over-buff your nails, since this can cause impairment.
   • If you cull to buff your nails with a file rather than a buffing block, use i with a very fine grit. Swipe it very lightly over your boom in just a few strokes. Otherwise, you may damage your nails.

2. 

   two

   Apply an alcohol wipe to clean off the dust. Wipe your buffed nails make clean with a lint-free wipe soaked in 91% isopropyl booze. This will both clean your nails and dehydrate them slightly, which will allow the gel foundation to adhere ameliorate.^[thirteen]

   • If you prefer, you tin can use disposable booze wipes, similar the kind you'd find in a kickoff aid kit.
   • Don't use a cotton ball, since this might leave fibers behind on your nails.

3. 

   3

   Brush on a layer of gel polish foundation. Apply a sparse coat of gel polish foundation to each nail, brushing from base to tip. This will act as the base glaze for your manicure. After brushing the foundation over your blast, swipe a fiddling along the complimentary edge of your nail to cap the tip.^[14]

   • Take care not to get the gel on your cuticle, since this will cause the base coat to peel off more than hands.^[xv]

4. 4

   Cure the foundation under an LED or UV lamp. Cure your nails under an LED or UV drying lamp for the recommended amount of time. Typically, this volition take 30 seconds under an LED lamp, or ane minute under a UV lamp.^[sixteen]

   • If you're concerned about UV exposure, protect your hands with a layer of sunscreen or protective manicure gloves.

5. v

   Wipe the surface of each nail with alcohol to remove the tacky layer. Once your foundation coat is cured, there will exist a sticky "inhibition layer" on your nails. To accept it off, wipe each of your nails with a lint-free wipe soaked in 91% isopropyl alcohol.^[17]

   • You can also use disposable booze wipes for this.

6. 

   6

   Apply 1 or ii thin coats of regular blast polish. Take the regular polish of your choice and wipe the castor on the edge of the bottle to remove whatsoever backlog polish. Apply an even, thin layer of the polish to each nail. Requite it 5 minutes to dry, and then brush on a 2nd coat if yous wish.^[18]

   • If you brand the polish as well thick, the gel topcoat won't adhere properly.
   • Take the polish up to the edge of your nails, merely don't cap off the tips. This volition help prevent chipping.^[19]

7. vii

   Allow the shine to dry completely. To keep the polish from wrinkling or smashing underneath the gel topcoat, yous must give the regular polish time to dry out. Ideally, you should expect several hours or fifty-fifty a full day earlier calculation the topcoat.^[20]

   • If you're using a quick-drying polish, you may exist able to become away with applying the topcoat later 15-20 minutes.^[21]

8. 

   8

   Add a layer of gel topcoat. Once you're sure the polish is completely dry out, brush on your gel topcoat. Apply it in an even layer, avoiding your cuticle, and then cap off the tip of your nail.^[22]

   • Capping off the edge of your nail volition aid seal in the regular polish and prevent chipping.

9. 9

   Cure the topcoat under the lamp for the recommended time. Place your nails inside your LED or UV nail lamp to cure the topcoat. Check the characterization on the bottle to determine how long you demand to cure your nails.^[23]

   • Typically, this will take 30 seconds nether an LED lamp, and two minutes nether a UV lamp.

10. 

    10

    Wipe off the tacky layer with an alcohol wipe. When you're done, wipe off the tacky layer with 91% isopropyl alcohol on a lint-free wipe. You should now have a beautiful and durable gelly sandwich manicure!^[24]

    • Add a little cuticle oil for extra wet if you desire. Wait at least a minute subsequently removing the tacky layer then you don't deadening your topcoat.^[25]

    Advertisement

Add together New Question

• Question

  How does the gel top coat bond to the regular nail polish, given that surfaces need to be tacky or non shiny for the gel to adhere properly?

  

  This reply was written by i of our trained team of researchers who validated it for accuracy and comprehensiveness.

  

  wikiHow Staff Editor

  Staff Reply

• Question

  How do I utilise regular nail shine to nail gel without it peeling off?

  

  This answer was written past one of our trained team of researchers who validated information technology for accuracy and comprehensiveness.

  

  wikiHow Staff Editor

  Staff Answer

  

  Support wikiHow by unlocking this staff-researched answer.

  If you want to combine regular nail polish with gel, it's best to seal in the smooth with a gel topcoat rather than putting the polish on superlative of the gel. Y'all can either utilise a layer of polish with a topcoat over it, or employ a gel basecoat, layer on the polish, and seal it all in with a gel topcoat.

• Question

  Can I add together a layer of colour when I have cured the top coat?

  

  This answer was written by one of our trained squad of researchers who validated it for accuracy and comprehensiveness.

  

  wikiHow Staff Editor

  Staff Answer

• Question

  Can yous use a gel blast polish and gel acme coat without UV?

  

  This answer was written by one of our trained team of researchers who validated it for accurateness and comprehensiveness.

  

  wikiHow Staff Editor

  Staff Answer

• Question

  When using a gel base glaze, do you accept to remove the tacky inhibition layer earlier putting regular boom shine on? Can you paint RNP over the tacky layer of the gel base coat that has been cured?

  

  This reply was written by 1 of our trained team of researchers who validated it for accuracy and comprehensiveness.

  

  wikiHow Staff Editor

  Staff Answer

• Question

  Every once in a while, when I take the tacky off with alcohol, I find a dull finish. What causes information technology?

  

  This answer was written by ane of our trained team of researchers who validated it for accuracy and comprehensiveness.

  

  wikiHow Staff Editor

  Staff Reply

• Question

  Would a gel base coat offer more than durability? Also, can regular polish exist cured nether my UV lamp?

  

  Cecilia Flores

  Top Answerer

  Only gel polish can be cured under a UV lamp. Regular shine dries on its ain, while gel polish requires a lamp and won't cure unless it's sat under the lamp. Use a gel base glaze, cure information technology, apply regular polish and wait for it to dry out completely, and so use a gel top glaze and cure it. This helps the mani to terminal longer and you won't have to buy a gel color.

• Question

  Will using a gel base instead of regular base of operations work better?

  

  In my experience, yes, a gel base is improve.

• Question

  How exercise I know which type of UV lite I accept?

  

  Await at the instructions for the unit y'all have. UV light will require a minute and a one-half to 2 minutes to cure, whereas a LED light unit will take nearly 30 seconds.

• Question

  Tin can I use these gel polishes without exposing my nails in UV lamps?

  

  They take gel polish with which you don't need to apply the UV lamp.

Show more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

Video

Things You'll Need

• Nail buffer
• Lint-complimentary corrective wipes
• 91% isopropyl alcohol
• Gel foundation
• Regular nail smoothen
• Gel topcoat
• UV or LED curing lamp

• Before applying whatever nail smooth, trim and file your nails to the desired length and shape. If you lot try to shape your nails later on applying the smooth, you'll damage your manicure.

Thanks for submitting a tip for review!

Advert

About This Article

Thanks to all authors for creating a page that has been read 469,655 times.

Did this commodity help you?

lawrencemorty1992.blogspot.com

Source: https://www.wikihow.com/Use-Both-Regular-and-UV-Gel-Nail-Polish-Together